Common fault treatment of heat shrink packaging machine

3 Comments

Common fault treatment of heat shrink packaging machine

1. The conveying network does not turn: the conveying switch fails, exchange; the speed control board is broken, exchange; the potentiometer is broken, exchange; the conveying motor is damaged, exchange; the conveying mechanism is stuck, check the fault;

2. The hot air motor of the heat shrinking machine does not turn: the hot air switch is damaged, exchange; the motor is damaged, exchange;

3. The heat shrink packaging machine is prone to accumulate materials in the center column. Reasons: poor shrink packaging of the heat shrink packaging machine, the size of the heat shrink packaging machine and the design size of the center column do not match, the sleeve labeling machine is not adjusted well, and the selection stability is high. Sleeve labeling machine that is well adjusted and has a high tolerance for the size of the heat shrinkable packaging machine, and the quality of the shrinking machine is controlled by the factory;

4. The sleeve label of the heat shrink packaging machine is not accurate, and the label cannot be sleeved in the specified position. Reason: the sleeve label machine is not adjusted well or the heat shrink packaging machine has static electricity. Solution: choose high stability, good adjustment and static electricity on the shrink machine For sleeve labeling machines with low interference, strengthen the technical training of operators and use static elimination equipment.

Tags:

Categories

Recent Posts

Recent Comments